UK Plug

Sometimes wires get damaged, or you end up buying an appliance from overseas. When this happens you may decide to simply fit a new plug rather than buy a new appliance.

When you need to wire a UK plug you only need to follow a few very simple steps.  If you need to wire a UK plug on to any appliance it is an easy job, and you can usually do it in 5 minutes flat!

1) Strip the wires, you will need to remove just over one inch of the white outer covering, and about half a centimetre of the inner wires.

2) Loosen the screw and take the plug apart and then loosen (Not undo) the three screws inside.

3) Feed the cable through the cable grip, tighten this slightly.  Insert the three smaller wires as per the diagram above. The wires are as follows

• Brown – Live – Middle Right Connection
• Green and Yellow – Earth – Top Connection
• Blue – Neutral – Bottom Left Connection

4) Tighten the three small wires securely

5) Tighten the cable grip and tug the wire to ensure it will not slip out during use.

6) Replace the outer cover, and you are done!

This is the simple easy way to wire a UK plug!